Aerotech AUTOMATION1-HyperWire, Руководство по оборудованию

Страница: 13 / 20

HyperWire Card Hardware Manual Chapter 1: HyperWire™ Card
1.3. Cables
The cables are SFP+ active optical cables. The are designed for use in 10-Gigabit Ethernet links.
Table 1-2: HyperWire Cable Part Numbers
Part Number Description
HYPERWIRE-AO10-5 HyperWire cable, active optical, 0.5 m
HYPERWIRE-AO10-10 HyperWire cable, active optical, 1.0 m
HYPERWIRE-AO10-30 HyperWire cable, active optical, 3.0 m
HYPERWIRE-AO10-50 HyperWire cable, active optical, 5.0 m
HYPERWIRE-AO10-200 HyperWire cable, active optical, 20.0 m
The connector module latches into the connector housing. Release the latch by pulling on the plastic pull tab
located near the connector module (
Figure 1-5 ).
Figure 1-5: Cable Pull Tab
Table 1-3: Cable Specifications
Specification Description
Cable Jacket Material PVC
Cable Flammability Rating Optical Fiber Nonconductive Riser (OFNR)
Cable Outer
Diameter
Minimum 2.8 mm
Typical 3.0 mm
Maximum 3.2 mm
Tensile Load
Short Term 200 N
Long Term 100 N
Crush Resistance 10 N/mm (minimum) [FOTP-41]
Impact Resistance 0.5 N·m (minimum) [FOTP-25]
Flexing 300 cycles [FOTP-104]
Twist Bend Exceeds FOTP-85 Fiber Optic Cable Twist Test
Bend Radius
Short Term 25 mm (minimum)
Long Term 30 mm (minimum)
Durability 100 Cycle Minutes (minimum)
www.aerotech.com 13