Chapter 2: Installation
WARNING
: The stage installation must be in accordance with the instructions provided
by this manual and any accompanying documentation. Failure to follow these
instructions could result in injury or damage to the equipment.
2.1. Unpacking and Handling the Stage
WARNING
: It is the responsibility of the customer to safely and carefully lift and move
the ANT95L.
l
Refer to
for stage mass specifications.
l
Use care when you move the ANT95L or you could negatively affect the performance
of it.
l
Lift this product only by the base.
l
For multi-axis assemblies, always lift the system by the lower axis.
l
Do not use the cables or the connectors to lift or move this product.
l
Make sure that all moving parts are secure before you move the stage. Unsecured
moving parts could shift and cause injury or damage to the equipment.
Carefully remove the stage from its protective shipping container. Gently set the stage on a smooth,
flat, and clean surface. Use compressed nitrogen or clean, dry, oil-free air to remove any dust or
debris that has collected during shipping.
Before you operate the stage, let it stabilize at room temperature for at least 12 hours. This will
ensure that all of the alignments, preloads, and tolerances are the same as they were when they
were tested at Aerotech.
Each stage has a label listing the system part number and serial number. These numbers contain
information necessary for maintenance or system hardware and software updates. Locate this label
and record the information for later reference.
Red, anodized aluminum shipping brackets have been installed to prevent unwanted motion
damage that could occur during shipment. The brackets must be removed before the ANT95L can be
operated. Retain the brackets and hardware for future use.
Figure 2-1:
Shipping Brackets
ANT95L Hardware Manual
Chapter 2: Installation
www.aerotech.com
15
Содержание ANT95L Series
