3
AEROSMITH INSULATION GAS TOOL OPERATIONAL MANUAL
AEROSMITH INSULATION GAS TOOL OPERATIONAL MANUAL
AEROSMITH INSULATION GAS TOOL OPERATIONAL MANUAL
2. Pushing the rear edge until it has “clicked”.
NOTE:
•
Make sure the fuel cell valve is attached
fi rmly, if not, gas leakage may occur and
create hazards to users and bystanders.
E. Installing/Removing fuel cell
Caution !
•
Make sure the trigger is not held while
inserting fuel cell.
•
Empty fasteners from the barrel before
installing fuel cell.
•
Do not press on the surface ground while
installing.
Steps:
1. Push up and pull to open the fuel door.
2. Insert the fuel cell, direct the jet nozzle into
the adaptor.
3. Put the can door over the valve and push it
down to latch.
4. For removing fuel cell, reverse the above
steps.
F. Installing and removing barrel
Caution !
•
Make sure the trigger is not held while
inserting barrel.
•
Do not press on the surface ground while
installing.
•
Do not cover the barrel with your hand while
installing.
Steps:
1. Make sure the adapter is in unlock position.
2. Insert the barrel into the adaoter.
3. Rotate the adapter to lock position until you
hear “click”.
G. Loading the pins
Caution !
•
Make sure the trigger is not held while
loading the pins.
•
Do not press on the surface ground while
loading.
Steps:
1. Insert the insulation fastener into the barrel
until it reaches the tip of pin guide.
2. For removing the insulation fastener, simply
pull the fastener out from the barrel.
H. Driving the pins
Caution !
•
Please READ and UNDERSTAND the
section “General Safety Instructions” for
personal and working environment safety.
•
If you spot of any abnormality about the tool,
contact nearest authorized serviceman for
inspection and repairing.
Steps:
1. Press the tool with suitble length of insulation
fasteners through the insulation material.
2. Press the Nose of the contact arm against
working surface (90° against the surface) fi rmly
until you hear the fan motor is working.
3. Pull the trigger, the pins are driven to the
