Section 2. SET UP PROCEDURE
The set up procedure should be carried out on a clean, non-abrasive surface.
ATTENTION:
After each set up procedure you must perform a preflight inspection of the glider.
2.1. Take the speedbar out of the bag, spread the uprights. Install the speedbar. Pass the flap’s and RVG’s
ropes through channels in the speedbar and the stoppers. Fix the speedbar using the quick-pins. Hook front
wire.
2.2. Rest the glider on the control bar, pull tips out of the D-spar, put the bags inside the D-spar, take the pin
of the nose hardware out, spread the wings (don’t take the bags off the D-spar ends), remove Velcro tapes.
2.3. For one side at a time:
Stand at the leading edge side,
take the bag off the D-spar end,
press on the tongues of the tip clamp
put tip on the hooks
turn the tongue of the tip clamp to the D-spar wall’s side
unroll the sail, holding both aileron and flap
put in the tip tube
open the zipper on the sail’s tip and put the tip rib and clamp wall in to the sail, close the zipper
connect the tip rib to the trailing edge tube
