3
COIL ROOFING NAILER CN45RA
tool.Always ensure that the tool has stopped before putting it down after use, in the interest of safety and to
prevent possible damage to the tool/user.
Keep proper footing at all times in order to ensure correct balance.
Do not use oxygen or any other combustible or bottled gas
to power
air-powered
tools. Failure to observe this warning can cause explosion and serious personal
Use a minimum of 25
’
(7.6m) of hose to connect the tools to the compressor.
Failure to comply will result in serious injury or loss of life.
Risk of electric shock:
Do not expose a compressor to rain. Store it
indoors. Disconnect
the compressor from power source before servicing. Compressor must be
grounded. Do not use grounding adaptor.
Risk of personal injury:
Do not direct compressed air from the air hose toward the user or other
personnel.
Risk of inhalation:
Never directly inhale the air produced by the compressor.
Risk of bursting:
Do not adjust the pressure switch or safety valve for any reason. They have been
preset at the factory for this compressor
’
s maximum pressure. Tampering with the pressure switch or
the safety valve
Risk of burns:
The pump and the manifold generate high temperatures. In order to avoid burns or
other injuries, do not touch the pump, the manifold or the transfer tube while the compressor is running.
Allow the parts to cool down before handling or servicing. Keep children away from the compressor at
all times.
Risk of bursting:
Make sure the regulator is adjusted so that the compressor outlet
pressure is set lower than the maximum operating pressure of the tool. Before
starting
the compressor, pull the ring on the safety valve to make sure the valve moves
freely.Drain water from tank after each use. Do not weld or repair tank. Relieve all
pressure in the hose before removing or attaching accessories.
WARNING!
Potential hazard that could result in serious injury or loss of life.
Do not allow unskilled or untrained individuals to operate the air powered tools.
Do not use the air powered tools for any task other than that it is designed to perform.
Do not use the air tools unless you have been trained to do so. Only a qualified person should use the tool.
Locate the compressor in a well-ventilated area for cooling, and must be a minimum of 12
”
(31cm) away from the nearest wall.
Protect the air hose and the power cord from damage and puncture. Inspect them for weak or worn spots every week, and replace them if
necessary .
Always wear hearing protection when using the air compressor. Failure to do so may result in hearing
loss.
Do not carry the compressor while it is running.
Do not operate the compressor if it is not in a stable position.
Do not operate the compressor on a rooftop or in an elevated position that could allow the unit to fall or be tipped
over. Always replace a damaged gauge before operating the unit again.
CAUTION!
Potential hazard that may result in moderate injury or damage to equipment.
Always ensure that the tool has stopped before connecting to the air supply.
