5
Framing Nailer ACHF9034 www.aeroprotools.com
It is recommended that a filter-regulator-lubricator is used and located as close to the tool as possible.
If a filter-regulator-lubricator in not installed, place up to 6 drops of compressor oil into the inlet plug before each use.
If a filter-regulator-lubricator is installed, keep the air filter clean. A dirty filter will reduce the air pressure to the tool,
which will cause reduction in power, efficiency, and general performance.
For optimal performance, install a quick connector to the tool and a quick coupler on the hose, if applicable.
Verify that all of the connections in the air supply system are sealed in order to prevent air from leaking.
NO. Description
NO.
Description
NO. Description
1
AEROPRO Air powered Framing nailer
4
Air Hose
7
Filter
2
Quick connector
5
Lubricator
8
Cut-off valve
3
Quick coupler
6
Regulator(0 to 8.3 Bar)
9
Air compressor
WARNING!
Potential hazard that could result in serious injury or loss of life.
Do not use the tool if it is not in proper working order.
Do not use oxygen,carbon dioxide or any other combustible, or bottled gas to power this tool.
Do not use this tool in the presence of any flammable liquids or gases.
Keep hands and other parts of the body away from the firing head during use.
Do not point the tool towards the operator or other people.
Never attempt to clear a jammed fastener while the air hose is connected.
Do not drive a fastener on top of an existing fastener. Failure to comply could lead to serious injury or loss of life.
TYPES OF FASTENERS
Please see the TECHNICAL SPECIFIACTIONS.
WARNING!
Potential hazard that could result in serious injury or loss of life.
The use of any other types of fasteners will cause the tool to jam. Failure to comply could lead to serious injury or loss of life.
OPERATING INSTRUCTIONS
4.1 Preparing a tool for first time operation
Please Read and observe these Operating Instruction before using the tool. Basic safety measures should always be strictly followed
to protect against damage to the equipment and personal injury to the user or other people working in the vicinity of operation.
WARNING!
Potential hazard that could result in serious injury or loss of life.
NEVER point tool at yourself or others in work area.
Keep fingers AWAY from trigger when not driving nails to avoid accidental firing.
Choice of triggering method is important.
Please
read and understand “Methods of Operation"below.
Before starting work, check the nailing operation switching device.
This nailer includes a nailing operation switching device.
