Blade 2
Building instructions - Blade 2
Page 5
Battery su Centre of Gravity
To set the correct Centre of Gravity install all the internal components including motors, cables, con-
nectors and RC system, fit the formers (8 + 9) and the two flight batteries (but don’t glue them!), and
adjust the position of the flight packs until the model balances at the stated point. The correct CG is 36
cm forward of the rearmost edge of the fuselage. Place the model on a length of tube located at this
point, and check that the CG really is correct.
Solder the four sockets (18) to the cables attached to the two speed controllers, and glue the sockets
(18) in the former (8). The four plugs can now be soldered directly to the NC batteries, using the
sockets installed in former (8) as a template. Cut a slot in the fuselage (1) under the canopy to accept
the former (8), to keep it accurately in position when it is glued in place. Please take great care to
connect the batteries with correct polarity. Sand off the burned edges from the joint areas of the
formers before gluing them in the fuselage.