2 |
P a g e
NOTE: Ensure the shifter cable is not located near or have direct contact
with extreme heat sources. It is recommended to either use a heat sleeve
over the cable or fabricate a heat shield to protect cable from all heat
sources.
INSTALLATION GUIDELINE
1.
Route the shifter cable to avoid kinks and sharp bends to allow a
smooth operation. Route the cable away from hot engine or
exhaust parts. We recommend the use of a heat guard or heat
shield to protect the shifter cable from extreme heat components
on the vehicle. Be sure to correctly secure your shifter cable so it
does not contact any moving objects.
2.
To attach the shifter cable to the cable bracket, remove the small jam nut, two small rubber dust boots, and one of the large nuts
and lock washer from the cable. Then insert the cable through the cable bracket, reinstall the lock washer and nut on the cable
(loosely at this stage, to allow room for adjustment), and reinstall the two rubber dust boots.
3.
Thread the swivel & pin onto the cable to about the middle of the threaded section, then reinstall, but do not tighten the jam nut at
this stage. Before proceeding, verify that forward gear selector pin and C-Clips are installed in the correct position that is required for
your application.
4.
Move the transmission selector lever by hand to the full rear position (Low). Shift the shifter mechanism to the Low gear position
(ratcheted all the way back). Adjust the large nuts on the cable so that the swivel will slide into the hole on the selector lever. Tighten
the large nuts completely. Be sure that the swivel will slide freely in and out of the hole in the selector lever.
Note:
The shifter will not operate correctly unless the correct hole in the shift lever is used as shown in the step 1.
5.
Leave the swivel out of the hole and move the selector lever to Park, all the way forward. Also move the shifter to Park position.
Reinsert the swivel into the hole in the selector lever. Check to see that the swivel will slide freely in and out of the hole in the
selector lever in this position. If it does not slip in freely, adjust the swivel slightly until it will slip into the hole in the lever.
