Aerobics PaceMaster ProClub LT, Руководство пользователя

Страница: 8 / 18

Testing Your Treadmill
Your ProClub LT has been adjusted and tested at the factory. However, due to changes that can occur during shipment, it should be tested
prior to use. Once you have assembled your treadmill and it is located where it will be used, proceed as follows. (Do not make any
adjustments unless necessary.) For the purpose of this test, DO NOT stand on the tread belt. Once tested, always start and finish on
the tread belt.
Step One:
After your treadmill is in place and plugged in to the wall outlet, insert the magnetic safety key into the recess on the control panel.
Step Two:
You will see the number 150 in the INCLINE display window and the SET WEIGHT indicator light will be blinking. This is where the user’s
weight is adjusted. The default weight set at the factory is 150 lbs. For the purpose of this test, it is not necessary to enter your actual weight
at this time.
Step Three:
Set the workout speed by pressing the SPEED + button until the SPEED display window shows 2.5 mph.
Step Four:
Press the START/STOP button. Within a few seconds, the tread belt will begin to move. If the tread belt does not move, or the treadmill
stops after a few seconds and displays an error code, make a note of the error code and contact the authorized PaceMaster retailer where
you purchased your treadmill.
Step Five:
After the treadmill has reached 2.5 mph, observe the tread belt to make sure it is reasonably centered. If the tread belt is not centered,
Immediately press the STOP button and refer to the CARE and MAINTENANCE section of this manual, under Centering The Tread Belt.
Once the tread belt is centered, run the treadmill at 2.5 mph for 2 minutes to be sure it remains centered.
Step Six:
To test the elevation, the tread belt must be moving. Press the arrow up button to raise the elevation to 3% incline. The elevation will be
displayed in the INCLINE display window. Once it reaches 3%, press the down arrow button to reduce the incline to 0%. If the treadmill
does not elevate, or stops after a few seconds and displays an error code, make a note of the error code and contact the authorized
PaceMaster retailer where you purchased your treadmill.
7