aero-stream AS1000-1, Инструкция по установке и эксплуатации

Страница: 42 / 56

42
© Copyright Aero-Stream, LLC 2003-2019 102821 Rev. D
Install High Water Alarm Float
1. Remove the clean out cover on the septic tank and determine the depth
of the water in the tank and record depth.
2. Determine the best location for the float mast so the movement of the
float is not interfering with the Bio-Brush clusters. Positioning the mast
in the tank corner with the float towards the corner typically works best.
3. Back out the screws in the receiver sections. See Figure 47. Insert the
mast sections into the receivers with the section containing the float
clamp at the upper most position. Tighten the screws until the head of
the screws bottom out on the receiver.
Figure 47, Screw Detail
4. Using the measurement of the water depth in step 1, mark a line on the
side of the PVC pipe measuring from the bottom of the base towards the
top end of the pipe.
5. Slide the float clamp up or down so the bottom of the clamp is two-(2)
inches below the water mark and tighten clamp. See Figure 48.
Figure 48, Float Clamp
6. Drill a 5/8-inch hole through the side of the riser to allow the float switch
cord to be pushed through. Reference Figure 39 for detail.
7. Feed the free end of the float switch through the hole drilled in step 6.
8. Lower the float assembly into the tank ensuring the pipe is in a vertical
position.