AERMEC Omnia ULI P Series, Инструкция по использованию и установке

Страница: 5 / 8

16
For anomalies don’t hesitate, contact the aftersales service immediately.
PROBLEM AND REMEDY
PROBLEM
Insufficient air flow at
outlet
Unit does not heat
Unit does not cool
Fan not turning
Condensation forming
on the external case of
the unit
PROBABLE CAUSE
Incorrect speed setting on control panel
Blocked filter
Obstructed air flow (inlet and/or outlet)
No hot water
Incorrect control panel setting
No cold water
Incorrect control panel setting
No electrical power
Water has not reached operating temperature.
Temperature and humidity limits specified by
“MINIMUM AVERAGE WATER TEMPERATURE” have
been reached
SOLUTION
Select the correct speed on the control panel
Clean the filter
Remove the obstacle
Check the boiler
Set the control panel
Check the chiller
Set the control panel
Check that there is electrical power
Check heater or chiller.
Check thermostat setting
Raise the water temperature above the
limits specified by “MINIMUM AVERAGE
WATER TEMPERATURE”