page 4 of 14
Please, keep the device wrapping in order to be able to send the device safe for
guarantee repair. In order to save space you open simply the adhesive tape with a
knife and you fold the carton.
3.Mode of functioning
The AD-air dryer is built particularly for air drying in closed rooms. That dehumidifier
can prevent the formation of condensation, eliminate too high air humidity and hold
a specific air humidity constant. The time which the dryer requires in order to
achieve a specific humidity depends essentially on the environmental conditions.
The attainable humidity value is equally dependent on the environmental conditions.
The AD-dehumidifier works according to the condensation principle with heat
recovery. The fan (shown indicatively below) suck the moist air through a cool
register (evaporator). The air becomes so far chilled under the point of
condensation here, that the moist air condense as water and flows through the
pump, out into a sump. The chilled and dried air is warmed up at the condenser
again. Through the heat pump effect, the outlet air is some degrees warmer than
the sucked room air. Useful energy can conducted up to 3-fold of the electrical
power consumption. The absolute moisture of air is lowered continuously by the
continuous circulation of the room air through the device. The surplus moisture is
removed safely and efficiently.
1 – wet room air
2 – dry air
3 – evaporator
4 – condenser
5 – built in pump
6 – compressor
7 - fan