WS3083
- 9 -
Date
Press the
MENU
key twice to select the DATE section, the DATE section digits will start flashing. Press the
ENTER
key
to shift the display between the following parameters and press
the
UP
or
DOWN
key to change the
value:
Date Format
Year
Month
Day
Time Alarm
After editing the Time Alarm it can be enabled or disabled by pressing
ON/OFF
while the hour or minute of
the Time Alarm is flashing. An alarm symbol
appears in the Time display section indicating the alarm
function has been enabled.
Note:
Press any key to mute the alarm.
Note
: Alarms can also be set for most of the weather variables (see below for instructions on setting). When
a set weather alarm condition has been triggered that particular alarm will sound for 120 seconds. The
corresponding value, ‘HI AL” or “LO AL” and the alarm symbol will flash until the weather condition no longer
meets the user’s set level. When the alarm is sounding press any key to mute the alarm.
Note:
Because of the preset default settings it may not be necessary for the majority of users to perform any
further basic settings - except for Relative Air Pressure (see below). Changes, however, can be easily
made as below.
Pressure
Press the
MENU
key three times to select the PRESSURE HISTORY section, the PRESSURE HISTORY section
digits will start flashing. Press the
UP
or
DOWN
key to select the bar graph time scale (either 12 hrs or 24 hrs).
Press the
MENU
key a fourth time to select the PRESSURE section, the PRESSURE section digits will start
flashing. Press the
UP
or
DOWN
key to change between Relative and Absolute air pressure.
Press the
ENTER
key to select the following modes, then press the
UP
or
DOWN
key to set the value:
Pressure units of measurement - hPa, mmHg or inHg (default hPa).
Relative pressure value - if you are significantly above sea level you will need to calibrate the air
