16
9 V phantom power at line input
The 9 V phantom power supplies instrument preamps
with power (instead of a battery) that are prepared
accordingly. Such preamps are connected to input 1 by
a stereo jack cable.
The phantom power can be switched on by the 9 V
switch. The yellow indicator lamp then lights up.
Sources that don‘t need phantom power should
always be connected via a mono jack cable (not stereo)
as a precaution. This way the phantom power cannot
get to the source and possibly damage it. Also make
sure that the plugs are fully plugged in.
Notes on the use of phantom power
Phantom power means remote power supply of an
audio device (e.g. microphone) via the audio line.
Only suitable devices should be connected to an input
with (activated) phantom power.
Such devices are also marked accordingly.
Please heed the permissible power consumption (see
technical data).
Some devices do not need phantom power
but tolerate it.
Other devices that have not been designed
explicitly for phantom power operation can
suffer from considerable malfunction and damage may
result as well.
In case of uncertainty please consult the
manufacturer of your accessories.
5.6 Stereo-Simulation
The Domino2.A is mono – thus L-out and R-out are
carrying the same output-signal. You can use these
sockets to connect additional active AER fullrangesys-
tems (e.g. AG 8/3, AS 281), whose levels are adjusted
by the pre master-control independent of the overall
volume (master) of your Domino2.A.
By activating the stereo-simulation
(stereo sim.-switch pressed), a stereo-like,
wider sound impression is generated.
On stage (Domino2.A as monitor) the sound remains
unchanged.
5.7 Insert
The
insert
-loop is an in-/output on a stereo-socket to
link different effect-devices (EQ, compressor etc.) in
serial mode with
tip = send
(input) and
ring = return
(output). This configuration allows several more appli-
cations, such as:
1. use as additional line-output
2. use as additional line-input
3. link between two or more AER-amps with insert-
feature (AG8, Domino, Compact ClassicPro)
For each of these applications you’ll need the appropri-
ate cable connection, e.g. use as line-output: stereo-
jack (tip and ring = hot, sleeve = ground) to mono-jack.
The particular
AER-link-application
(s. no. 3 - link
between AER-amps) is represented on page 19. In link-
operation it is assured, that the signals of all connected
amps are hearable on all devices, even with different
effect settings. You just have to be aware, that the
different levels depend on each other.
This setting (in combination with active loudspeakers,
pre master
-function) works as a complete and easily
operated reinforcement/monitor system.
We wish you lots of fun playing your
Domino
2A!
