8-7-2019
Dual Nano Switch user guide : Aeotec Group
https://aeotec.freshdesk.com/support/solutions/articles/6000178928-dual-nano-switch-user-guide-zw132-and-zw140-
11/15
Yellow
[7.5A, 13.5A)
Red
[13.5A, 15.5A)
AU
Green
[0A, 5A)
Yellow
[5A, 9A)
Red
[9A, 10.5A)
EU
Green
[0A, 5A)
Yellow
[5A, 9A)
Red
[9A, 10.5A)
Removing Dual Nano Switch from a Z-Wave network.
Your Dual Nano Switch can be removed from your Z-Wave network at any time. You’ll need to use your Z-Wave network’s main controller. To set your Z-Wave
controller/gateway into removal mode, please refer to the respective section within your controller instruction manual.
1.
Set your Z-Wave controller into removal mode.
2.
Press the Action Button on the Dual Nano Switch once or toggle the external manual switch 3 times in fast succession.
3.
if the Dual Nano Switch has been successfully removed from your Z-Wave network, its RGB LED will remain colourful gradient. If the removal was unsuccessful, the RGB
LED will still be solid (following the state of the output load), repeat the instructions above from step 1.
Advanced functions.
Changing mode on the External Switch/Button Control.
The Dual Nano Switch can be controlled via 2-state (flip/flop) external/manual switch, momentary push button or the 3-way switch. When you first use Dual Nano Switch for the
first time, it will try to automatically detect your external switch type, toggle the button on the manual switch once and wait 2 seconds for the Dual Nano Switch to detect the
type of manual switch.
If you find that Dual Nano Switch has incorrectly detected the wrong switch type, you can force Dual Nano Switch to use a different mode with each switch using 2 separate
methods.
Set external switch using Action Button on Dual Nano Switch.
