AEOEZW100
Routing Multisenor
Firmware Version : 1.4
Quick Start
A
This is a Z-Wave actuator.
Power on the MultiSensor. The MultiSensor’s LED will blink slowly when you short press the Action Button. Set the primary controller into
inclusion mode (If you don’t know how to do this, refer to its manual). Press the Action Button. If the inclusion is successful, the
MultiSensor’s LED will be kept turning on for 8 seconds when you short press the Action Button. If the LED is still in slow blink, you need to
repeat the process from setting the controller into inclusion mode onward.
Please refer to the chapters below for detailed information about all aspects of the products usage.
What is Z-Wave?
This device is equipped with wireless communication complying to the Z-Wave standard. Z-Wave is the
international standard for
wireless communication
in smart homes and buildings. It is using the
frequency of 868.42 MHz
to realize a very stable and secure
communication. Each message is reconfirmed (
two-way communication
) and every mains powered node can act as a repeater for other
nodes (
meshed network
) in case the receiver is not in direct wireless range of the transmitter.
