Operation
Modes Program
1. Connect the plug to the power socket and locate the dryer to point the nozzle at
the pet.
2. Turn on the power switch and the dryer starts to blow. Turn the wind speed knob to
adjust the wind speed.
3. Turn on the heater switch and the wind will be heated. Turn the heater knob to set
the temperature of the wind.
4. If negative ions are needed, turn on the negative ion switch and the wind will blow
with negative ions.
Installation
1. Insert the sliding pipe into the fixing cover and
rotate the knob on the fixing cover to fix.
2. Lock tightly at the height you need with the
triangular height-adjusting handle.
3. The dryer windpipe fixture angle could be adjusted
by moving the windpipe up and down easily. After long
time operation, the joint between the dryer head and
hanging ear may go loose. When finding the tension
screws on both sides get loose, turning the slot on it
clockwise could tighten the screws. (See Fig.8).
4. After long time operation, the joint between the
supporting circle and sliding pipe may go loose and
cause accidental windpipe movement. If needed, turn
lock knob for suitable friction force to fix the dryer
head. (See Fig.8).
TD-906 Ionic Stand Dryer
Lock Knob
Tension Fixture Screw
Wall Bracket
Bolt
Hook Lock
Protector Plate
Hanger
Screw
Stopper
Bolt
Wall
Nut
Wall Plate
Fig. 6
Fig. 5
Fig. 4
Fig. 7
Fig. 8
Tension Fixture Screw
The tension fixture screws could be adjusted when needed.
The turning lock knob could be used for suitable friction force.
Note:
It takes 3-5 minutes for the hot air from the machine to reach a stable temperature.
20
30
40
50
60
70
0.21
7.5
7.5
7.5
7.5
7.5
0.33
11.7
11.7
11.7
11.7
11.7
50
1800
1800
1800
1800
1800
78
2800
2800
2800
2800
2800
OFF
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
0-25
0-25
0-25
0-25
0-25
0-25
240V
CURRENT
(A)
WIND
SPEED
(m/s)
WIND
TEMP
(˚C)
POWER
(W)
GREEN
LIGHT
RED
LIGHT
PEAK VALUE
CURRENT(A)
PEAK VALUE
POWER(W)
240V
240V
240V
6
7
