1 7
WWW.AEM-TEST.COM
[email protected] | Version # : 2.2
TestPro CV100
User Manual
•
•
•
Select [Connector: Generic Cat 6A].
Select [Generic Shielded].
Select [CAT 6A].
Follow a similar process for choosing connectors:
ii: Add New Cable
There are cases that the cable being used to test is not yet
available in AEM TestPro cable database. In this case, users
can add a cable in the database to be used for testing &
certification. To add new cable part number to the TestPro’s
database, contact AEM support @ customercare@aem-
test.com
•
•
Select [Cable: Generic Cat 6A].
Select [Add].
Name – name or part number of the new cable
Manufacturer – manufacturer name of the cable.
The new cable will be saved under this name in the
database.
Grade – cable grade (CAT3 to CAT8)
Type – UTP, STP, FTP, etc.Impedance: 100 Ohms
Pair Combination: all pairs enabled by default
When all fields are completed, select [Add] to save the
new cable in the database.
•
f. Label Schemes
Labeling allows user to identify the associated physical
locations (i.e., building, room, cabinet, rack ,port, etc.). These
labels will be used to save the test results to the TestPro.
i: Create New Label
•
•
Select [Label Scheme: Simple Label]. A preview of the
simple labels will be displayed.
Select [Edit] to view or to add to the list of label schemes.
Select [Add] to create a new label.
•
Key in the desired label name as well as the descriptions
for [Start] and [End].
Select [Add] to finish creating the label.
Select [Yes] to the dialog box confirming the new label
as the current label scheme.
•
•
•
Note: The text in Start label should be lower than the
End label i.e., 01 against 10. The text should match as
well i.e., first 4 characters are alphabet the end label
should also start with alphabet.
Refer this section to
ii: Import Custom Label
g. Operator
Adding Operator name in a project and profile is another
important step in documenting the test result. When test
reports are generated it includes the operator name to
identify who conducted the certification test.
Select [Operator: Default]. A preview of the operators
saved in Testpro will be displayed.
Select [Add] to add new operator.
Key in the operator’s name or initials and select [Ok].
•
•
•