13
2/5/2019 - DOCUMENT NUMBER: 10-2226
© 2019 AEM Performance Electronics
30-2226 6 Channel CAN Sensor Module
AEMnet (CAN Bus) Output
WHITE WIRE = / CANH
GREEN WIRE = AEMnet- / CANL
CAN DBC definition files are available at
www.aemelectronics.com
Bus Termination
All AEMnet/CAN networks must be terminated to have an
equivalent of approximately 60 Ohms of resistance.
Generally, this means a 120 Ohm resistor connected in
parallel to /AEMnet- (or CANH/CANL) at both
physical ends of the bus run.
bit rate
500
kb/sec
format
29
bit ID
terminating resistor
None
endianness
big / Motorola
DLC
8
0x0000B600 at 100Hz
Byte
Label
Data Type
Scaling
Offset
Range
0
Analog1
16 bit unsigned
1 Ohm/bit
0
0 to 65535 Ohm
1
2
Analog2
16 bit unsigned
1 Ohm/bit
0
0 to 65535 Ohm
3
4
Analog3
16 bit unsigned
0.001 V/bit
0
0 to 65.535 V
5
6
Analog4
16 bit unsigned
0.001 V/bit
0
0 to 65.535 V
7
0x0000B601 at 50Hz
Byte
Label
Data Type
Scaling
Offset
Range
0
Tacho
16 bit unsigned
0.1 Hz/bit
0
0 to 6553.5 Hz
1
2
n/a
n/a
n/a
n/a
n/a
3
4
n/a
n/a
n/a
n/a
n/a
5
6
FuelLevel
8 bit unsigned
1 Ohm/bit
0
0 to 255 Ohm
7
Battery Voltage
8 bit unsigned
0.1 V/bit
0
0 to 25.5 V
12 Month Limited Warranty
AEM Performance Electronics w arrants to the consumer that all AEM ELECTRONICS products w ill be free from defects in material and
w orkmanship for a period of tw elve months from date of the original purchase. Products that fail w ithin this 12-month w arranty period w ill be
repaired or replaced w hen determined by AEM that the product failed due to defects in material or w orkmanship. This w arranty is limited to the
repair or replacement, at AEM’s discretion, of the AEM Electronics part. In no event shall this w arranty exceed the original purchase price of the
AEM ELECTRONICS part nor shall AEM ELECTRONICS be responsible for special, incidental or consequential damages or cost incurred due to the
failure of this product.
Warranty claims to AEM ELECTRONICS must be transportation prepaid and accompanied by dated proof of purchase. This w arranty applies only
to the original purchaser of product and is non-transferable. All implied w arranties shall be limited in duration to the said 12-month w arranty period.
Improper use or installation, accident, abuse, unauthorized repairs or alterations voids this w arranty.
AEM ELECTRONICS disclaims any liability for consequential damages due to breach of any w ritten or implied w arranty on all products
manufactured by AEM ELECTRONICS.
Warranty returns w ill only be accepted by AEM ELECTRONICS w hen accompanied by a valid Return Merchandise Authorization (RMA) number.
Product must be received by AEM ELECTRONICS w ithin 30 days of the date the RMA is issued.
Please note that before AEM ELECTRONICS can issue an RMA for any electronic product, it is first necessary for the installer or end user to
contact the tech line at 1-800-423-0046 to discuss the problem. Most issues can be resolved over the phone. Under no circumstances should a
system be returned, or an RMA requested before the above process transpires. AEM ELECTRONICS w ill not be responsible for products that are
installed incorrectly, installed in a non-approved application, misused, or tampered w ith.
Fuel Pumps installed w ith incorrect polarity (+&- w ires crossed) w ill not be w arranted. Proper fuel filtration before and after the fuel pump are
essential to fuel pump life. Any pump returned w ith contamination w ill not be w arranted.
Any AEM ELECTRONICS product, excluding discontinued products, can be returned for repair if it is out of the w arranty period. There is a minimum
charge for inspection and diagnosis of AEM ELECTRONICS parts w hich are out of w arranty. Parts used in the repair of AEM ELECTRONICS
electronic components w ill be extra. AEM ELECTRONICS w ill provide an estimate of repairs and must receive w ritten or electronic authorization
before repairs are made to the product.
Need additional help? Contact the AEM Performance Electronics tech department at 1-800-423-0046 or email us at [email protected].
