Note)
If you have a 2001+ vehicle, the accessory
hose shown in
step j
will have a connector
attached to it. In this case, remove the connector
and insert the barbed fitting included in the kit
into the hose. Attach the length of 5/8” hose
included in the kit to the other end of the barbed
fitting. Slide the other end of the tube onto the
nipple and secure it in place with the 1” hose
clamp. The figure at right shows the layout of
this assembly.
A B
7
j) On 2000 and earlier models refer to figure A. On 2001+ refer to
figure B for vacuum hose routing.
l) Attach the ¼” hose to the nipple at the throttle
body from
step a.
k) Reattach breather hose and secure with spring
clamp.
