10
6. Reassemble Vehicle
a. Position the inlet pipes for the best fitment. Be sure that the pipes or any other components do not contact any part
of the vehicle. Tighten the rubber mount, all bolts, and hose clamps.
b. Check for proper hood clearance. Re-adjust pipes if necessary and re-tighten them.
c. Inspect the engine bay for any loose tools and check that all fasteners that were moved or removed are properly
tightened.
d. Reconnect the negative battery terminal and start engine. Let the vehicle idle for 3 minutes. Perform a final
inspection before driving the vehicle.
7. CARB Sticker Placement
a. The C.A.R.B. exemption sticker, (included), must be visible under the hood so that an emissions inspector can see
it when the vehicle is required to be tested for emissions. California requires testing every two years, other states
may vary.
h. Install the belly pan with the 9 clips, 7 screws,
and 2 bolts removed in steps 2f and 2g.
AEM
®
intake system installed
f.
For Most Applications:
Install the supplied ½”
ID hose between the crank case vent on the head
cover and the nipple on the upper intake pipe.
Secure the ½” hose with two small hose clamps.
g.
On some 5.7L engines:
Connect the stock
crank case vent hose to the supplied plastic adap-
tor nipple. Connect a 4” section of the ½” ID hose
onto the other end of plastic adaptor nipple. Con-
nect the hose to the intake pipe and secure with
the small hose clamps as shown.
