3
Read and understand these instructions BEFORE attempting to install this product.
Failure to follow installation instructions and not using the provided hardware
may damage the intake tube, throttle body and engine.
1. Preparing Vehicle
a. Make sure vehicle is parked on a level surface.
b. Set parking brake.
c. If engine has run in the past two hours, let it cool down.
d. Disconnect negative battery terminal.
e. Raise the front of the vehicle with a jack. Refer to your owner’s manual for proper
jack and jack stand placement to properly support vehicle.
f. Do not discard stock components after removal of the factory system.
2. Removal of Stock System
a. Stock intake system. Remove the
engine cover by grasping firmly on
lower end and carefully lifting up.
b. Loosen spring clamps to detach
crank case breather hose and
recirculating valve hose from
intake tube.
d. Remove the two plastic clips shown
above and pull up on the air inlet
snorkel to remove.
c. Loosen the stock hose clamp on
turbo inlet using a 10mm socket
and ratchet.
