AEG TR838P4C, Руководство пользователя

Страница: 24 / 36

Error code Possible cause Remedy
EH0
The mains supply is unstable. When the appliance is showing
EH0, please wait until main supply
is stable than press start. If the ap‐
pliance pause the cycle without
any indication then press the cycle
start. If the warning will occur
check the power cord / socket in‐
tegrity or main supply.
If the display shows other error codes, deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.
In case of different problem with the tumble dryer check the table below for possible
solutions.
11.2 Troubleshooting
Problem Possible cause Remedy
The tumble dry‐
er does not op‐
erate.
The tumble dryer is not connected
to the mains supply.
Connect it to the mains socket.
Check the fuse in the fuse box (do‐
mestic installation).
The door is open. Close the door.
The Zap./Vyp. button was not
pushed.
Push the Zap./Vyp. button.
The Start/Pauza button was not
touched.
Touch the Start/Pauza button.
The appliance is in standby mode. Push the Zap./Vyp. button.
Unsatisfactory
drying result.
Incorrect programme selection.
Select a suitable programme.
1)
The filter is clogged.
Clean the filter.
2)
Stupeň sušení option was set to
suché k žehlení.
3)
Change Stupeň sušení option to a
higher level.
The load was too large. Do not exceed the maximum load
size.
The airflow slots are clogged. Clean the airflow slots at the bot‐
tom of the appliance.
There is some dirt on the humidity
sensor in the drum.
Clean the front surface of the
drum.
The dryness level was not set to
the desired level.
Adjust the dryness level.
4)
The condenser is clogged.
Clean the condenser.
2)
www.aeg.com 24