The appliance starts and the LED above the button stops flashing
and stays on.
9.10 Program change
To change a program:
1. Push the Aan/Uit button to turn the appliance off.
2. Push the Aan/Uit button again to turn on the appliance.
3. Set a new program.
9.11 Programme end
Clean the filter and drain the water container after each drying
cycle. (See chapter CARE AND CLEANING.)
If the drying cycle is finished, the symbol appears on the display.
If the Zoemer option is activated, the acoustic signal sounds
intermittently for 1 minute.
If you do not turn off the appliance, the anti-crease phase starts
(not active with all programmes). Flashing symbol signals the
execution of the anti-crease phase. Laundry can be removed
during this phase.
To remove the laundry:
1. Push the Aan/Uit button for 2 seconds to turn the appliance off.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Possible causes of unsatisfactory drying results:
• Inadequate default dryness level settings. See chapter
Adjustment of default dryness level
• Room temperature is too low or too high. Optimal room
temperature is between 18°-25°C.
38/64
DAILY USE
