AEG SWS74500G0, Руководство пользователя

Страница: 4 / 56

4 www.aeg.com
• if the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
2.1
Installation
Warning! Only a qualified person must
install this appliance.
• Remove all the packaging.
• Do not install or use a damaged appliance.
• Obey the installation instruction supplied
with the appliance.
• Always be careful when you move the appli-
ance because it is heavy. Always wear safety
gloves.
• Make sure the air can circulate around the
appliance.
• Wait at least 4 hours before connec ting the
appliance to the power supply. This is to al-
low the oil to flow back in the compressor.
• Do not install the appliance close to radia-
tors or cookers, oven or hobs.
The rear of
the appliance must stand against the wall.
• Do not install the appliance where there is
direct sunlight.
• Do not install this appliance in areas that
are too humid or too colds, such as the
construction appendices, garages or wine
cellars.
• When you move the appliance, lift it by the
front edge to avoid scratching the floor.
2.2 Electrical connection
Warning! Risk of fire and electrical shock.
• The appliance must be earthed.
• All electrical connections should be made
by a qualified electrician.
• Make sure that the electrical information on
the rating plate agrees with the power sup-
ply. if not contact an electrician.
• Always use a correctly installed shockproof
socket.
• Do not use multi-plug adapters and exten-
sion cables.
• Make sure not to cause damage to the elec-
trical components (e.g. mains plug, mains
cable, compressor). Contact the Service
or an elect rician to change the electrical
components.
• The mains cable must stay below the level of
the mains plug.
• Connect the mains plug to the mains socket
only at the end of the installation. Make sure
that there is access to the mains plug after
the installation.
• Do not pull the mains cable to disconnect
the appliance. Always pull the mains plug.
2.3 Use
Warning!
Risk of fire and electrical shock
or fire.
• Do not change the specification of this
appliance.
• Do not put electrical appliances (e.g. ice
cream makers) in the appliance unless they
are stated applicable by the manufacturer.
• Be careful not to cause damage to the
refrigerant circuit. it contains isobutane
(R600a), a natural gas with a high level of
environmental compatibility. This gas is
flammable.
• if damage occurs to the refrigerant circuit,
make sure that there are no flames and
sources of ignition in the room. Ventilate
the room.
• Do not let hot items to touch the plastic
parts of the appliance.
• Do not store flammable gas and liquid in the
appliance.
• Do not put flammable products or items
that are wet with flammable products in,
near or on the appliance.
• Do not touch the compressor or the con-
denser. They are hot.
2.4
Care and cleaning
Warning! RRisk of injury or damage to
the appliance.
• Before maintenance, deactivate the appli-
ance and disconnect the mains plug from
the mains socket.
• This appliance contains hydrocarbons in the
cooling unit. Only a qualified person must
do the maintenance and the recharging of
the unit.
• Regularly examine the drain of the appli-
ance and if necessary, clean it. if the drain
is blocked, defrosted water collects in the
bottom of the appliance.
2. SAFETy INSTRUCTIONS