AEG SCS51813S1, Руководство пользователя

Страница: 13 / 24

Problem Possible cause Solution
Temperature cannot be set. The FROSTMATIC or COOL-
MATIC function is switched
on. Switch off FROSTMATIC or
COOLMATIC manually, or
wait until the function resets
automatically to set the tem-
perature. Refer to "FROST-
MATIC or COOLMATIC
function".
The temperature in the ap-
pliance is too low/too high. The temperature regulator is
not set correctly. Set a higher/lower tempera-
ture.
The door is not closed cor-
rectly. Refer to "Closing the door".
The food products' tempera-
ture is too high. Let the food products tem-
perature decrease to room
temperature before storage.
Many food products are
stored at the same time. Store less food products at
the same time.
The thickness of the frost is
greater than 4-5 mm. Defrost the appliance.
The door has been opened
often. Open the door only if neces-
sary.
The FROSTMATIC function
is switched on. Refer to "FROSTMATIC
function".
There is no cold air circula-
tion in the appliance. Make sure that there is cold
air circulation in the appli-
ance.
If the advice does not lead
to the desired result, call the
nearest Authorized Service
Centre.
8.2
Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
8.3
Closing the door
1.
Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
9.
INSTALLATION
9.1
Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
ENGLISH 13