AEG SCB61811TS, Руководство пользователя

Страница: 13 / 72

Problem Possible cause Solution
There is too much frost and
ice. The door is not closed cor-
rectly or the gasket is de-
formed/dirty. Refer to "Closing the door".
Temperature is set incor-
rectly. Refer to "Operation" .
The compressor does not
start immediately after
pressing the "Frostmatic",
or after changing the tem-
perature. This is normal, no error has
occurred. The compressor starts after a
period of time.
Water flows inside the refrig-
erator. Food products prevent the
water to flow into the wa-
ter collector. Make sure that food products
do not touch the rear plate.
The water outlet is clog-
ged. Clean the water outlet.
Water flows on the floor. The melting water outlet is
not connected to the
evaporative tray above the
compressor. Attach the melting water out-
let to the evaporative tray.
Temperature cannot be set. The "Frostmatic function"
is switched on. Switch off "Frostmatic func-
tion" manually, or wait until
the function resets automati-
cally to set the temperature.
Refer to "Frostmatic function".
The temperature in the ap-
pliance is too low/too high. The temperature regulator
is not set correctly. Set a higher/lower tempera-
ture.
The door is not closed cor-
rectly. Refer to "Closing the door".
The food products' tem-
perature is too high. Let the food products temper-
ature decrease to room tem-
perature before storage.
Many food products are
stored at the same time. Add less food products at the
same time.
The thickness of the frost is
greater than 4-5 mm. Defrost the appliance.
The door has been
opened often. Open the door only if necessa-
ry.
The "Frostmatic function"
is switched on. Refer to "Frostmatic function".
ENGLISH 13