8.3
Ventilation requirements
The airflow behind the appliance must
be sufficient.
5 cm
min.
200 cm
2
min.
200 cm
2
CAUTION!
Refer to the assembly
instructions for the
installation.
8.4
Door reversibility
1.
Loosen and remove the upper pin.
2.
Remove the upper door.
3.
Remove the spacer.
4.
Loosen the middle hinge.
5.
Remove the lower door.
6.
Loosen and remove the lower pin.
7.
Tighten the lower pin on the
opposite side.
8.
Install the lower door.
9.
Tighten the middle hinge.
10.
Install the spacer.
11.
Install the upper door.
12.
Tighten the upper pin.
Do a final check to make
sure that:
• All screws are tightened.
• The magnetic seal
adheres to the cabinet.
• The door opens and
closes correctly.
If the ambient temperature
is cold (i.e. in Winter), the
gasket may not fit perfectly
to the cabinet. In that case,
wait for the natural fitting of
the gasket.
In case you do not want to
carry out the above
mentioned operations,
contact the nearest
Authorised Service Centre.
The Authorised Service
specialist will carry out the
reversibility of the doors at
your cost.
8.5
Installing the appliance
CAUTION!
Make sure that the mains
cable can move freely.
1.
If necessary cut the adhesive sealing
strip and then apply it to the
appliance as shown in figure.
ENGLISH
15
Содержание S53620CSX2
