AEG RCB53424TW, Руководство пользователя

Страница: 9 / 52

Problem Possible cause Solution
The lamp does not work. The lamp is in stand-by
mode. Close and open the door.
The lamp does not work. The lamp is defective. Contact the nearest Author-
ised Service Centre.
The compressor operates
continually. Temperature is set incor-
rectly. Refer to "Operation"/"Control
panel" chapter.
Many food products were
put in at the same time. Wait a few hours and then
check the temperature again.
The room temperature is
too high. Refer to climate class chart on
the rating plate.
Food products placed in
the appliance were too
warm. Allow food products to cool to
room temperature before stor-
ing.
The FROSTMATIC function
is switched on. Refer to "FROSTMATIC func-
tion".
The compressor does not
start immediately after
pressing the FROSTMATIC
or after changing the tem-
perature. This is normal, no error has
occurred. The compressor starts after
some time.
Water flows inside the re-
frigerator. The water outlet is clog-
ged. Clean the water outlet.
Food products prevent wa-
ter from flowing into the
water collector. Make sure that food products
do not touch the rear plate.
Water flows on the floor. The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor. Attach the melting water out-
let to the evaporative tray.
Temperature cannot be set. The FROSTMATIC or
COOLMATIC function is
switched on.
Switch off FROSTMATIC or
COOLMATIC manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "FROSTMATIC
or COOLMATIC function".
The temperature in the ap-
pliance is too low/too high. The temperature regulator
is not set correctly. Set a higher/lower tempera-
ture.
The food products temper-
ature is too high. Let the food products temper-
ature decrease to room tem-
perature before storage.
ENGLISH 9