AEG MC 4421 N CD/MP3, Инструкция по эксплуатации, Страница: 5 / 42

English
41
11 button (on/ operational readiness)
12 Extendable supports for the speaker boxes
13 AUX IN jack
14 SD memory card slot
15 PHONES headphone jack
16 Cover
17 USB jack
18 Stand
19 CD tray
20 MEMORY/CLOCK button (memory/ time)
21 10-/P- / 10+/P+ buttons (10 music titles forward or back-
ward / preset station location)
22 STOP button (stop)
23 REW button (previous title)
24 F.FWD button (next title)
25 PLAY/PAUSE button (playback/ pause)
26 Speaker boxes
Back
Power cord
Dipole antenna
Battery compartment (power reserve)
SPEAKER R/L speaker connections
Suspension eyes for wall mounting
Remote Control
1 MEM/PROG button (memory/ program)
2
button (mute)
3 REPEAT button (playback mode)
4
button (increase volume)

button (next title)
button (reduce volume)

button (previous title)
5 AL.SET button (set alarm time)
6 OPEN/CLOSE button (open/ close CD tray)
7 FUNCTION button (select source)
8 SLEEP button (sleep timer)
9 SNOOZE button (snooze)
10 TIME SET button (set time)
11 M+/M- buttons (10 music titles forward or back / preset
station location)
12 button (playback/ pause)
13 button (stop)
14 button (on/ operational readiness)
First Use of the Device/Introduction
• Select a proper place for the device. A dry, level and slip
proof surface is suitable.
• Make sure the device is vented sufficiently!
• Remove the protective film from the device, if present.
Mounting the stand
If you do not want to mount the device to the wall, place the
device onto the supplied stand.
Connecting speakers
1. Pull the brackets out on both sides for the loudspeaker
boxes (12).
2. Place the right and the left box onto the track from
above.
3. Connect the speaker boxes with the connections
SPEAKER R and L on the back of the device.
NOTE:
You may also position the loudspeaker boxes next to the
device by using the extendable supports on the back of the
boxes.
Wall mounting (Mounting material not included)
You can also mount the device to the wall.
CAUTION:
Make sure beforehand whether there are cables in the wall
which could be damaged!
NOTE: Check the reach of the cable!
To mount the device, make sure that an easily accessible
plug outlet is available within reach of the power cable.
The distance between the mountings for wall mounting is
120 mm.
1. Drill two holes horizontally at that distance.
2. Fit dowels and screws into the holes.
3. Hang the device onto the screws. Check that it is secure.
Power supply
• Make sure the grid voltage corresponds to the figures on
the rating plate.
• Connect the mains plug to a properly installed wall
socket.
NOTE:
• Disconnect from mains power supply during longer
periods of non-use.
• If you have not inserted any backup batteries, the
storage of the time and the radio station will be lost as
soon as the power supply has been interrupted.
Inserting the backup battery
(Batteries not included)
If there should be a power outage or if the mains plug were
to be disconnected from the electrical outlet, then the set-
tings will be maintained with inserted backup batteries.
1. Open the battery compartment on the back.
2. Insert 2 batteries of the type AA/R6 1.5 V into the battery
compartment. Ensure the correct polarity (see battery
compartment).
3. Close the battery compartment again.