AEG LP 1480 F, Руководство пользователя

Страница: 18 / 28

Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment, if
not fill the detergent again.
10.12 Opening the door when
the programme operates
CAUTION!
If the temperature and level
of the water in the drum are
too high, the door lock
indicator
stays on and
you cannot open the door.
To open the door proceed as follows:
1. Press the button Ein/Aus - Marche/
Arrêt for some seconds to deactivate
the appliance.
2. Wait for some minutes and then
open carefully the appliance door.
3.
Close the appliance door.
4. Activate the appliance and set the
programme again.
10.13
Opening the door when
the delay start is active
While the delay start operates, the
appliance door is locked.
To open the appliance door:
1. Press button Start/Pause - Départ/
Pause.
In the display the door lock indicator
goes off.
2. Open the appliance door.
3. Close the door and press button
Start/Pause - Départ/Pause.
The delay start continues.
10.14 End of cycle
When the programme has finished, the
appliance stops automatically. The
acoustic signal operates (if it is active).
In the display comes on and the door
locked indicator
goes off.
The indicator of Start/Pause - Départ/
Pause button goes off.
1. Press button Ein/Aus - Marche/Arrêt
to deactivate the appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the
appliance again, the display
show the end of the last set
programme. Turn the
programme knob to set a
new cycle.
2. Remove the laundry from the
appliance.
3. Make sure that the drum is empty.
4. Keep the door ajar, to prevent
mildew and odours
10.15 Draining water out after
end of cycle
The washing programme is completed,
but there is water in the drum :
The drum turns regularly to prevent the
creases in the laundry.
The door lock indicator is on. The
door stays locked.
You must drain the water to open the
door:
1. If necessary, decrease the spin
speed.
2. Press the Start/Pause - Départ/Pause
button.
The appliance drains the water and
spins.
3. When the programme is completed
and the door lock indicator
goes
off, you can open the door .
4. Press Ein/Aus - Marche/Arrêt some
seconds to deactivate the appliance.
The appliance drains and
spins automatically after
approximately18 hours.
10.16 AUTO Stand-by option
The AUTO Stand-by function
automatically deactivates the appliance
to decrease the energy consumption
when:
• You do not use the appliance for 5
minutes before you press Start/Pause
- Départ/Pause button.
www.aeg.com 18