• Always keep the airflow slots at the
bottom of the appliance clear.
• Make sure there is good airflow where
the appliance is to be installed.
9.2
Adjustment of default
dryness level
To change the default dryness level:
1.
Turn the appliance on.
2.
Select 1 of the available programs.
3.
Touch and hold down the
Quiet
Mode
and
Refresh
buttons at the
same time.
One of the symbols appears on the
display:
- Maximum dryness
- Extra dryness
- Standard dryness
4.
Touch the
Start/Pause
button
repeatedly until you reach the
desired dryness level.
Dryness lev-
el
Display symbol
Maximum
dryness
Extra dry-
ness
Standard
dryness
5.
To memorise the setting touch and
hold down the
Quiet Mode
and
Refresh
buttons at the same time for
approximately 2 seconds.
9.3
Deactivating the tank
indicator
The water container indicator is activated
by default. It illuminates at the end of the
drying cycle or during the cycle if the
water reservoir is full. If the draining kit is
installed the water container is drained
automatically and the indicator can be
deactivated.
To deactivate the indicator:
1.
Turn the appliance on.
2.
Select 1 of the available programs.
3.
Touch and hold down
Refresh
and
Time Drying
buttons at the same
time.
One of 2 configurations is possible:
• the Tank indicator:
is on if the
symbol
appears - the
water container indicator is
permanently
activated
• the Tank indicator:
is off if the
symbol
appears - the
water container indicator is
permanently
deactivated
10.
CARE AND CLEANING
10.1
Cleaning the filter
At the end of each cycle the
Filter
symbol comes on the display and you
must clean the filter.
The filter collects the fluff
during the drying cycle.
1.
Open the door. Pull the filter up.
2.
Push the hook to open the filter.
www.aeg.com
16
