Loading door does not close.
Fine strainer not in place and/
or mesh filter not locked in
place.
Install fine strainer and/or snap
large mesh filter into place.
When a button is pressed,
Err
appears on the LCD.
Washing protection. After the
start of the programme, the
option can no longer be set.
Turn the programme knob to
OFF. Set the programme again.
Drum light does not work.
Programme selector in OFF po
-
sition.
Turn programme selector to
DRUM LIGHT or to any pro
-
gramme.
Defective light bulb.
Replace light bulb (see next
section).
Displayed programme time
changes erratically or stays un
-
changed for a long time.
Programme time is corrected
automatically depending on
type and volume of laundry
and level of dampness.
Automatic process; this is not a
machine fault.
Programme inactive, empty
water tank icon is on.
Condensate tank is full.
Empty condensate tank, then
start programme with START
PAUSE button.
Drying cycle ends shortly after
programme starts.
Not enough washing loaded or
washing loaded is too dry for
selected programme.
Select time programme or
higher drying level (e.g. INTEN
-
SIVE DRY instead of STORAGE
DRY).
Drying cycle lasts an unusually
long time. Note: After around 5
hours the drying cycle ends au
-
tomatically (see „Drying cycle
complete ”).
Lint filter clogged.
Clean lint filter.
Fluff filter clogged.
Clean fluff filter.
Load volume too big.
Reduce load volume.
Laundry insufficiently spun.
Laundry must be adequately
spun.
Particularly high room temper
-
ature. Temporary switching off
of the compressor to avoid
overload.
Automatic process, there is no
fault with the appliance. If pos
-
sible, lower the room tempera
-
ture.
Changing the bulb for interior lighting
Only use a special bulb which is designed specially for dryers. The special bulb can
be obtained from your local service centre.
When the appliance is switched on, the interior lighting switches itself off after 4
minutes when the door is open.
What to do if ...
29
