AEG LAVAMAT LS 60840 L, Руководство пользователя

Страница: 30 / 36

Carefully level by screwing the adjustable feet in or out. Never place cardboard, wood or
similar materials under the machine to compensate for any unevenness in the floor.
Water inlet
This appliance must be connected to a cold water supply.
1. Connect the hose to a tap with a 3/4”
thread. Always use the hose supplied with
the appliance.
Do not use the hose from your previ‐
ous machine to connect to the water
supply.
2. The other end of the inlet hose which
connects to the machine can be turned as
showed in the picture.
Do not place the inlet hose down‐
wards. Angle the hose to the left or
right depending on the position of
your water tap.
3. Set the hose correctly by loosening the
ring nut. After positioning the inlet hose,
be sure to tighten the ring nut again to
prevent leaks.
The inlet hose must not be lengthened. If it is too short and you do not wish to move the
tap, you will have to purchase a new, longer hose specially designed for this type of use.
Installation should comply with local water authority and building regulations require‐
ments. A minimum water pressure of 0.05 MPa is required for safe operation of the appli‐
ance.
Before connecting up the machine to new pipework or to pipework that has not been used
for some time, run off a reasonable amount of water to flush out any debris that may have
collected in the pipes.
Water drainage
The end of the drain hose can be positioned in three ways:
1.
Hooked over the edge of a sink using the plastic hose guide supplied with the
machine.
In this case, make sure the end cannot come unhooked when the machine is emptying.
30 Installation