28
3.
Remove both plastic caps sideways.
3
Special spanner A and sealing caps B
(2 units) and C (1 unit) come with
the appliance.
4.
Use special spanner A to remove
screw D and the compression spring.
5.
Turn sealing cap C upside down as
shown in the illustration.
6.
Use sealing cap C to cap the hole.
7.
Use special spanner A to remove the
two screws E.
8.
Use special spanner A to remove the
four screws F.
9.
Remove transit bar G.
10.
Screw in the four screws F again.
11.
Use sealing caps B to cap the two
large holes.
Important:
Press all sealing caps B
(2 items) and C (1 item) in firmly so
that they snap into the rear wall.
Where to install
Important!
The washing machine must not be operated in a room
where there is a danger of frost. There is a risk of frost damage or ad-
verse effect on the perfomance of the machine. Frost damage is not
covered under the warranty.
•
The surface on which the appliance is to be installed must be firm
and level. Do not install the appliance on carpeted floors or soft floor
coverings.
•
The surface on which the appliance is to be installed must be clean
and dry and free from grease, so that the appliance does not slide.
