Water inlet (cold water connection only)
Connect the hose
to a tap with a
3/4” thread.
Installation should
comply with local
water authority
and building reg-
ulations’ require-
ments.
Set the hose correctly by loosening the ring nut. After positioning the
inlet hose, be sure to tighten the ring nut again to prevent leaks.
Do not connect to a hot water supply.
Water drainage
The appliance drain hose should hook into a standpipe, the hook in the
drain hose is formed using the
plastic “U-Piece” supplied. The
standpipe should have an inter-
nal diameter of approximately
38 mm (see diagram on page 52)
thus ensuring there is an air
break between the drain hose
and standpipe.
When discharging into a standpipe ensure that the top of the curve in
the hose end is no more than 90 cm (35.4”) and no less than 60 cm
(23.6”) above floor level.
The upright standpipe should have a mini-
mum length of 30 cm (12”) from the bottom
of the elbow to the top of the pipe (see dia-
gram). Make sure that it is designed in such a
way that the end of the drain hose cannot be
covered with water.
51
Installation
3 pin
Max.
90 cm.
(35.4")
Min.60 cm. (23.6")
Min. 30 cm.(12")
38 mm.(1/ ") diameter
standpipe
1
2
132993820.qxd 3/4/03 12:25 PM Pagina 51 (Nero/Process Black pellicola)
Содержание LAVAMAT 12710 TURBO ELECTRONIC
Страница 55: ...55 ...