AEG L8TE73C, Руководство пользователя, Страница: 21 / 36

10.11 Cancelling a running
programme
1. Press button Aan/Uit to cancel the
programme and to deactivate the
appliance.
2.
Press button Aan/Uit again to
activate the appliance.
Now, you can set a new washing
programme.
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment, if
not fill the detergent again.
10.12 The ProSense load
detection
The programme duration in
the display is referred to a
medium/high load .
After touching the Start/Pauze button,
the maximum declared load indicator
goes off, the indicator
flashes, the
ProSense starts the laundry load
detection:
1. The appliance detects the load in the
first 30 seconds: the indicator and
the time dots flash, the drum
rotates shortly.
2. At the end of the load detection, the
indicator goes off and the time
dots stop flashing. The programme
duration will be adjusted accordingly
and could increase or decrease. After
further 30 seconds, the water filling
starts.
At the end of the load detection, in case
of drum overload , the indicator is
flashing in the display:
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Start/Pauze button to start the
programme again. The ProSense phase
can be repeated up to three times (see
point 1).
Important! If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
About 20 minutes after the
programme start, the
programme duration could
be adjusted again
depending on the capacity
of water absorption of the
fabrics.
The ProSense detection is
carried out with complete
washing programmes only
(no skipping phase
selected).
10.13
Opening the Lid when
the programme operates
CAUTION!
If the temperature and level
of the water in the drum are
too high, the
indicator
stays on and you cannot
open the lid.
To open the lid proceed as follows:
1. Press the button Aan/Uit for some
seconds to deactivate the appliance.
2. Wait for some minutes and then
open carefully the lid.
3. Close the lid.
4. Activate the appliance and set the
programme again.
10.14
Opening the Lid when
the delay start is active
While the delay start operates, the
appliance lid is locked.
To open the appliance lid:
1. Press button Start/Pauze.
The indicator goes off.
2. Open the appliance lid.
3. Close the lid and press button Start/
Pauze.
The delay start continues.
ENGLISH 21