Make sure that the flap does not cause a
blockage when you close the drawer.
10.5
Setting a programme
1.
Turn the programme dial to select
the desired washing programme.
The indicator of Mode - Wash button
illuminates.
The indicator of the Start/Pause button
flashes.
The display shows an indicative
programme duration and the maximum
load.
2.
To change the temperature and/or
the spin speed, touch the related
buttons.
3.
If desired, set one or more options
by touching the related buttons. The
related indicators illuminate on the
display and the given information
changes accordingly.
If a selection is
not possible
an acoustic signal sounds
and the display shows
.
10.6
Starting a programme
Touch the Start/Pause button to start the
programme. It is not possible to start the
programme when the indicator of the
button is off and doesn't flash (e.g. the
door is open).
The related indicator stops flashing and
stays on.
The programme starts, the door is
locked. The display shows the indicator
.
The drain pump can operate
shortly before the appliance
fills water.
10.7
Starting a programme
with the delay start
1.
Touch the Delay Start button
repeatedly until the display shows
the desired delay time. The related
indicator comes on.
2.
Touch the Start/Pause button. The
appliance door locks and starts the
countdown of the delay start. The
display shows the indicator
.
When the countdown is completed, the
programme starts automatically.
Cancelling the delay start after
the countdown has started
To cancel the delay start:
1.
Touch the Start/Pause button to
pause the appliance. The related
indicator flashes.
2.
Touch the Delay Start button
repeatedly until the display shows .
3.
Touch the Start/Pause button again
to start the programme immediately.
Changing the delay start after
the countdown has started
To change the delay start:
1.
Touch the Start/Pause button to
pause the appliance. The related
indicator flashes.
2.
Touch the Delay Start button
repeatedly until the display shows
the desired delay time.
3.
Touch the Start/Pause button again
to start the new countdown.
10.8
The AutoAdjust System
load detection
The programme duration in
the display is referred to a
medium/high load
.
After touching the Start/Pause button,
the maximum declared load indicator
goes off, the AutoAdjust System starts
the laundry load detection:
1.
The appliance detects the load in the
first 30 seconds. In the programmes
where Time Save is available, during
this phase the Time Save bars
placed below the time digits play a
simple animation. The drum rotates
shortly.
2.
The programme duration could be
adjusted accordingly and could
increase or decrease. After further 30
seconds, the water filling starts.
At the end of the load detection,
in case
of drum overload
, the indicator
is
flashing in the display:
ENGLISH
33
Содержание L7WC8632BI
Страница 1: ...USER MANUAL EN User Manual Washer Dryer L7WC8632BI ...
Страница 52: ...www aeg com shop 157018221 A 462018 ...