30
What to do, if...
Try to rectify minor faults on the dishwasher with the aid of the instructions given
here.
...a flashing fault code appears
an audible signal informs you that an alarm has been activated, in the display
appears one of the following flashing alarms: AL1 - AL2 - AL3 - AL4 - AL5 - AL6 -
AL7 and the indicator light of the phase under way is flashing. They are indicative of
a fault in the dishwasher that you can probably rectify yourself.
- Press the ON/OFF push button to switch the dishwasher off.
- Open the door and carry out the following suggested corrective actions.
Fault code
"WATER" indicator light
flashes and/or alarm AL5
"DOOR" indicator light
flashes
Alarm AL6
Alarm AL4
Alarms AL1 - AL2 - AL3 -
AL7 - AL8
The water tap is closed.
The door has not been
properly closed.
Close the door.
Open the water tap.
The mains water supply has
been cut off.
Wait for the supply to be
restored.
The inlet hose may be
squashed or bent.
The inlet hose may be
blocked.
The drain hose may be
squashed or bent. The drain
hose extension is not
correct.
The sink may be blocked.
Protection against flooding
is active.
General
Close the water tap and
contact the Service Force
Centre.
Switch off the dishwasher,
switch back on and start a
wash programme. If the
fault code reappears
contact the Service Force
Centre.
Clear any blockages.
Reposition correctly the
drain hose. Follow the
instructions for
connecting to the waste.
Switch off the water
supply and clean the filter.
Reposition correctly the
hose.
Possible cause
Remedy
Once you have checked the possible causes listed above, switch on the dishwasher
and start a wash programme, if the fault code reappears contact the Service Force
Centre.
152983 79/2 8-02-2002 17:22 Pagina 30