AEG HK683320FG, Руководство пользователя

Страница: 14 / 20

Problem Possible cause Remedy
The STOP+GO function
operates. Refer to the chapter
“Daily Use”.
There is water or fat
stains on the control
panel. Clean the control panel.
An acoustic signal
sounds and the appli-
ance deactivates.
An acoustic signal
sounds when the appli-
ance is deactivated. You put something on
one or more sensor
fields. Remove the object from
the sensor fields.
The residual heat indica-
tor does not change col-
ours. The cooking zone is not
hot because it operated
only for a short time. If the cooking zone oper-
ated sufficiently long to
be hot, speak to the
service centre.
The Automatic Heat Up
function does not oper-
ate. The cooking zone is hot. Let the cooking zone be-
come sufficiently cool.
The highest heat setting
is set. The highest heat setting
has the same power as
the Automatic Heat Up
function.
The heat setting changes
between two levels. The Power management
is activated. Refer to “Power man-
agement”.
The sensor fields be-
come hot. The cookware is too
large or you put it too
near to the controls. Put large cookware on
the rear cooking zones if
necessary.
There is no signal when
you touch the panel sen-
sor fields. The signals are deactiva-
ted. Activate the signals (refer
to “Deactivation and ac-
tivation of the sounds”).
The backlight is on, but
the contrast of the dis-
play is bad. The hot cookware is on
the display. Remove the object and
let the appliance be-
come sufficiently cool. If
the contrast is not clear,
speak to the service cen-
tre.
II and text come on. The Automatic Switch
Off operates. Deactivate the appliance
and activate it again.
comes on.
The Child Safety Device
or the Lock function op-
erates. Refer to the chapter
“Daily Use”.
? comes on. No cookware is on the
cooking zone. Put cookware on the
cooking zone.
The cookware is incor-
rect. Use the correct cook-
ware.
14 www.aeg.com