AEG HD955100NB, Руководство пользователя

Страница: 10 / 60

Make sure that you connect
the blue neutral cable to the
terminal with a letter "N" on
it. Connect the brown (or
black) phase cable to the
terminal which has a letter
"L". Keep the phase cable
connected at all times.
To prevent contact between the cable
and the appliance below the hob use the
clamps which are on the side of the
cabinet.
A
A. Rigid copper pipe or flexible pipe of
stainless steel
3.7 Connection cable
• The hob is supplied with the
connection cable.
• Replace the damaged mains cable
only with the spare parts cable. Speak
to your local Authorised Service
Center.
WARNING!
All electrical connections
must be made by a qualified
electrician.
CAUTION!
Do not drill or solder the
wire ends. This is strictly
forbidden!
CAUTION!
Do not connect the cable
without cable end sleeve.
Use only the special connection cable or
its equivalent. The cable type is:
H05V2V2-F T90.
Make sure that the cable section is
applicable to the voltage and the
working temperature. The yellow / green
earth wire must be approximately 2 cm
longer than the brown (or black) phase
wire.
Two-phase connection
1. Remove the cable end sleeve from
black and brown wires.
2. Remove an insulation of the brown
and black cable ends.
3. Apply a new wire end sleeve of 2.5
mm² on each cable end. (special tool
required).
Cable cross section
N
L
230V~
One-phase connection - 230 V~
Green - yellow
N Blue
L Black and brown
3.8 Attaching the seal - On-top
installation
1. Clean the worktop around the cut
out area.
2. Attach the supplied thinner seal
stripe to the lower edge of the hob
along the outer edge of the glass
ceramic. Do not extend it. Make sure
that the ends of the seal stripe are
located in the middle of one side of
the hob.
3. Add some mm when you cut the seal
stripe to the length.
4. Push the two ends of seal stripe
together.
www.aeg.com 10