AEG FM6300G-AN, Инструкция по установке и эксплуатации

Страница: 15 / 28

15
•
The settings for this appliance are given on the appliance’s rating
plate.
•
The present settings for the type of gas and gas pressure are given on
a sticker near the connection pipe.
•
This appliance is not connected to an exhaust gas outlet. It must be
connected in accordance with the installation conditions that apply.
Special attention is to be paid to suitable ventilation.
Gas connection
• The 1/2’’ gas connection pipe is located on the lefthand side of the
back of the appliance.
• Burner rail end piece with nut (1),
gasket (2) and adjustable fitting
(3) are to be assembled as illus-
trated.
•
It is recommended that a gas
safety socket is used.
•
The connection can be permanent
or using a permitted gas safety
hose assembly with a socket.
•
If using a gas safety hose assem-
bly ensure that it is not fed
through hot areas. The hose as-
sembly must be positioned such
that it is not in contact with anything and must not come into con-
tact with a moveable part of the built-in unit (e.g. a drawer).
Cutting the seal to length
• A sealing tape is stuck to the underside of the appliance. The two
ends overlap and must be cut off flush.
1
Warning!
After installation always check the tightness of the connections using a
soap solution.
Never use a flame to check the tightness.
Using the appliance for the first time
• Ignite each ring burner and test burning stability at maximum and
minimum power.