22
However, to ensure accessi-
bility to the gas connection
there should generally be at
least 50 mm between the rear
of the hole for the gas hob
and the wall behind it.
1. Cut a hole in the worktop of the
given dimensions, see “Technical
data”, “installation dimensions”.
2. Place the hob upside down on a
soft underlay. Make sure not to
scratch the top surface.
3. Mount the fixings in the holes in
the sides of the base box. (See
fig.).
4. Insert the hob in the hole and
tighten the fixings to the worktop
with a screwdriver.
Mounted clamping fittings
11
Burners
Make quite sure the burner
ring and burner cap are posi-
tioned correctly over the
burner top.
For correct combustion the burner
rings and burner cap must be posi-
tioned correctly over the burner
body. If the burner rings and caps
are off-centre, the gas flame will
burn incorrectly and the burner caps
may be ruined in a short space of
time.
Control knobs
The control knobs have the follow-
ing settings:
Off:
O
Minimum:
f
Maximum:
e
1. Press down the control knob for
the desired burner
2. Hold the knob down while turning
it to the left to
e
.
3. Keep the knob pressed down for
4-5 seconds. Then release it and turn
the knob to the required setting.
Burner ring
Burner cap
Burner body
Safety device
Right
Wrong
