AEG Favorit 88025 VI, Руководство пользователя, Страница: 28 / 40

Installation instructions
Installation
If floor is not level, adjust
levelling legs to s uit
POWE R S UPPL Y
230/240V - 1 0 Amps
The hos e s hould not be
extended by more than
2 metres or water pump-
out problems ma y occu r
Fix drain hose max of
10mm below the top of
the dishwashe r
Remove entire plastic
membrane from sink trap
spigot & fit drain hose to spigot
with clamp
There should be a minimum
2mm gap between the top of
the dishwasher and
underside of bench top
• K ickplate fixing screws •
Gap on both sides should be
equal, & no greater than
5mm per side.
600mm max.
300mm min.
Secure dishwasher with
brackets and screws provided
Inlet water supply
• Cold water pressure: 800 kPa max - 50
kPa min
• Water flow rate 10 L/minute min.
• If cold water pressure is in excess of
800 kPa, a pressure-reducing valve
should be used. Check for leaks.
WARNING!
Make sure that mains plug is disconnected from the mains socket during installation.
Install the appliance under a counter (kitchen worktop or sink).
If a repair is necessary, the appliance must be easily accessible for the engineer.
Put the appliance adjacent to a water tap and drain.
For the venting of the appliance only water hoses and mains cable openings are necessary.
The appliance has adjustable feet to allow the adjustment of its height.
Make sure that the water inlet hose, the drain hose and the mains cable are not kinked or
squashed, when you insert the appliance.
28 Installation