AEG Dishwasher, Руководство пользователя

Страница: 22 / 24

WATER DRAIN CONNECTION
max.
4000 mm
min. 400 mm
max. 850 mm
Connect the water drain hose to:
• The sink spigot. Attach the water
drain hose under the kitchen counter.
This prevents that waste water from
the sink goes back to the appliance.
• A stand pipe with vent-hole. The in-
ternal diameter must be minimum 40
mm.
Remove the sink plug when the appli-
ance drains. This prevents water to go
back to the appliance.
An extension hose for the water drain
hose must be shorter than 2 m and with
the same diameter as the water drain
hose.
A
If you connect the water drain hose to a
trap spigot under the sink, remove the
plastic membrane (
A ). A not complete
removal of the membrane causes a
blockage in the spigot and problems
with drain.
The appliance has a non-return valve
that prevents dirty water to go back to
the appliance. If there is a non-return
valve in the sink spigot, remove it to
prevent the appliance to drain incor-
rectly.
TECHNICAL INFORMATION
Dimensions Width / Height / Depth (mm) 596 / 850 / 610
Electrical connection Refer to the rating plate.
Voltage 220-240 V
Frequency 50 Hz
Water supply pressure Min. / max. (bar / MPa) (0.5 / 0.05 ) / (8 / 0.8 )
Water supply
1)
Cold water or hot water
2) max. 60 °C
Capacity Place settings 12
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
2) If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian
energy), use the hot water supply to decrease energy consumption.
22