AEG BPS551020M, Руководство пользователя

Страница: 30 / 40

10.3 Removing the shelf
supports
To clean the oven, remove the shelf
supports.
CAUTION!
Be careful when you remove
the shelf supports.
1. Pull the front of the shelf support
away from the side wall.
2. Pull the rear end of the shelf support
away from the side wall and remove
it.
2
1
Install the removed accessories in the
opposite sequence.
10.4 Pyrolysis
CAUTION!
Do not start the Pyrolysis if
the Plus Steam button is
pressed in.
CAUTION!
Remove all accessories and
removable shelf supports.
Do not start the Pyrolysis if
you did not fully close the
oven door. In some models,
the display shows "C3"
when this error occurs.
WARNING!
The appliance becomes very
hot. There is a risk of burns.
CAUTION!
If there are other appliances
installed in the same
cabinet, do not use them
when the Pyrolysis function
operates. It can cause
damage to the appliance.
1. Remove the worst dirt manually.
2. Clean the inner side of the door with
hot water, so that the residues do not
burn from the hot air.
3. Set the Pyrolysis function. Refer to
"Oven functions".
4. When flashes, press or to
set the necessary procedure:
Option Description
P1 If the oven is
not very dirty.
Time of the
procedure: 1
h 30 min.
P2 If you cannot
easily remove
the dirt. Time
of the proce-
dure: 3 h.
After 2 seconds the procedure starts.
You can use the End function to delay
the start of the cleaning procedure.
During the Pyrolysis the oven lamp is off.
5. To change the default length of the
procedure (
P1 or P2 ), press to set
, and then press or to set
the length of the cleaning procedure.
6. When the oven is at its set
temperature, the door locks. The
display shows the symbol and the
bars of the heat indicator until the
door unlocks.
7.
When Pyrolysis is completed, the
display shows the time of day. The
oven door stays locked.
8. When the appliance is cool again, an
acoustic signal sounds and the door
unlocks.
www.aeg.com 30