7
Operating and Indicator Panel
A B
C
D
E
F G
H I
+
°C
°C
-
ON/OFF
FROSTMATIC
ALARMOFF
A.
ON/OFF light
B.
Freezer button ON/OFF (green)
C.
Temperature setting button (warmest)
D.
Temperature display
E.
Temperature setting button (coldest)
F.
Fast freezing light (amber)
G.
Frostmatic button
H.
Alarm light (red)
I.
Alarm reset button
Temperature setting buttons
The temperature is adjusted using the „C“ and „E“ buttons. These buttons are
connected to the temperature display.
•
The temperature display is switched over from the display of the ACTUAL
temperature (Temperature display is illuminated) to the display of the DESI-
RED temperature (Temperature display flashes) by pressing one of the two
buttons, „C“ or „E“.
•
Each time one of the two buttons is pressed again the DESIRED temperatu-
re is adjusted by 1 °C. The DESIRED temperature must be reached within 24
hours.
If neither button is pressed, the temperature display automatically switches
back after a short period (approx. 5 sec.) to the display of the ACTUAL tem-
perature.
DESIRED temperature means:
The temperature that has been selected for inside the freezer. The DESIRED
temperature is indicated by flashing numbers.
14
If, after carrying out the necessary checks there is still a fault with your
appliance please contact your local AEG Service Force Centre.
In guarantee customers should ensure that the suggested checks have
been made as the engineer will make a charge if the fault is not a mecha-
nical or electrical breakdown.
Please note that proof of purchase is required for any in-guarantee service
calls.
Heavy build up of frost, possi-
bly also on the door seal.
Door seal is not air tight (pos-
sibly after changing over the
hinges).
Carefully warm the leaking
sections of the door seal with
a hair dryer (not hotter than
approx. 50 °C). At the same
time shape the warmed door
seal by hand until it sits cor-
rectly.
The freezer temperature is not
sufficient, red light lights up,
temperature alarm sounds
The appliance is near a heat
source.
Temperature is not properly
adjusted.
Please look in the "Initial Start
Up" section.
Press the frostmatic switch
Door was open for an exten-
ded period.
Please look in the "Installation
location" section.
A large quantity of warm
food was placed in the
appliance within the last 24
hours.
Open the door only as long as
necessary.
Symptom
Possible Cause
Remedy
The compressor starts after a
period of time.
This is normal, no error has
occurred.
The compressor does not start
immediately after changing
the temperature setting.
Appliance does not work no
pilot light is illuminated.
Appliance is not switched on
Switch on the appliance.
Mains plug is not plugged in
or is loose.
Insert mains plug.
Fuse has blown or is defective.
Check fuse, replace if neces-
sary.
Socket is defective.
Mains malfunctions are to be
corrected by an electrician.
Appliance cools too much.
Temperature is set too cold.
Press the temperature setting
button to a warmer setting.
Green light does not light up,
yellow light lights up when
frostmatic fuction is activa-
ted, appliance is on.
Green light faulty.
Please inform your local AEG
Service Force Centre
Yellow light does not light up,
when frostmatic fuction is
activated, appliance is on.
Yellow light faulty.
Please inform your local AEG
Service Force Centre
