818 22 78-00/5
17
Prior to Initial Start–Up
1
Before connecting the appliance to the mains and switching it on for
the first time, leave the appliance to stand for 30 minutes if it was
transported upright. After transporting it on its side, the appliance
must be left to stand for 2 hours before switching it on. This is
necessary to allow the refrigerant to flow back into the compressor.
Otherwise the compressor may be damaged.
0
1.
Please clean the appliance interior and all accessories prior to initial
start-up (see section: “Maintenance and Cleaning”).
2.
The appliance must be correctly installed in accordance with the chap-
ter "Installation" before it is switched on for the first time. Special care
should be taken that the mains voltage and frequency available corre-
spond with the appliance’s rating plate.
3.
Remove the cold accumulation block from the appliance.
4.
Only put the cold accumulation block to freeze in the top compartment
after the optimal storage temperature of –18 °C has been reached.
5.
After 24 hours place the cold accumulation block in the uppermost
compartment, at the front, above the frozen food.
Initial use
0
1.
Insert plug into mains socket.
2.
Press ON/OFF button.
A warning tone sounds and the red warning light flashes indicating
that the required storage temperature has not yet been reached. The
compressor starts and then runs automatically.
3.
Press the ALARM OFF button to switch off the warning tone.
4.
Set temperature to -18°C or colder (see section: "Temperature Adjust-
ment").
Important!
Wait until the freezer compartment has reached a tempera-
ture of –18 °C, or the red warning light has gone out, before storing
frozen food.
