background image

4

4

 

If four LEDs turn yellow, the battery pack is fully charged. The battery 
pack capacity is between 85%-100%.

 

If three LEDs turn yellow and one is off, the battery pack capacity is 
between 60%-85%.

 

If two LEDs turn yellow and the other two are off, the battery pack 
capacity is between 35%-60%.

 

If only one LED turns yellow and others are off, the battery pack 
capacity is lower than 35%. In this case, the battery pack can be used 
as usual until automatically turned off by the control program.

 

If only one LED flashes yellow and others are off, the battery pack 
capacity is less than 10%. The under-voltage protection is activated.

BATTERY PROTECTION

See page 7.

AEG 58V lithium-ion batteries are designed with features that protect the 
lithium-ion cells and maximise battery life. If the tool stops during use, the 
following may be the causes:

 

Over-current protection is active. The maximum draw of the battery 
pack has been exceeded, causing it to automatically stop powering 
the product.

 

Over-temperature protection is active. Excessive temperatures caused 
the battery pack to stop powering the product.

If the tool still does not work, the battery may not be sufficiently charged. 
Recharge the battery.
To determine if a battery protection feature is active, press the charge level 
indicator button:

 

If the second and third LEDs are flashing, the over-current protection 
is active. Remove the battery pack to reduce the current.

 

If the first and last LEDs are flashing, the over-temperature protection 
is active. Remove the battery pack and allow it to cool down.

CHARGING THE BATTERY PACK

Battery packs are shipped in a low charge condition. Charge them until the 
green LED on the front of the charger turns on.
If the charger does not charge the battery pack under normal 
circumstances, contact an authorised service centre for related advice.

Remove the battery pack when charging is complete.

TO CHARGE

 

Use a battery pack only with the recommended charger.

 

Connect the charger to the power supply. Make sure that the power 
supply is the normal household voltage, 220-240 V AC only, 50 Hz.

 

Make sure that the latch of the battery pack clicks into place and the 
battery pack is secured in the charger before beginning operation.

 

Slide the battery pack along the groove of the charger.

 

Press down on the battery pack to ensure that the contacts on the 
battery pack engage properly with contacts in the charger.

 

Do not place the charger and battery pack in an area of extreme heat 
or cold. They work best at normal room temperature.

NOTE:

 

The charger and battery pack should be placed in a location where 

the temperature is more than 10°C but less than 38°C.

 

The battery pack becomes slightly warm to the touch while charging. 
This is normal and does not indicate a problem.

 

After charging is complete, the charger green LED remains on until 
either the battery pack has been removed from the charger or the 
charger has been removed from the power supply.

 

After charging is complete, the battery pack LED indicator remains on 
for 1 min then turns off. But if the battery pack has been removed from 
the power supply, the battery pack LED indicator turns off.

 

When batteries become fully charged, unplug the charger from the 
power supply and remove the battery pack.

 

Press the latch of the battery pack to remove the battery pack from 
the charger.

CHARGING A HOT BATTERY PACK

If the battery pack is above the normal temperature range, the charger 
red LED flashes and the green LED turns off. When the battery pack cools 
down to approximately 45°C, the charger automatically begins fast charge 
mode.

CHARGING A COOL BATTERY PACK

If the battery pack temperature is below 3°C, the charger red LED flashes 
and the green LED turns off. When the battery warms to a temperature of 
more than 5°C, the charger automatically begins charge mode.

COLD WEATHER OPERATION 

The lithium-ion battery pack can be used in temperatures down to -20°C. 
Put the battery pack on a tool and use the tool in a light duty application. 
After about a minute, the pack will have warmed up and begin operating 
normally.

MAINTENANCE AND STORAGE

AEG battery packs have been designed to provide maximum trouble-
free life. However, like all batteries, they will eventually wear out. Do not 
disassemble the battery pack and attempt to replace the battery cells. 
Handling of these batteries, especially when wearing rings and jewelry, 
could result in a serious burn.
To obtain the longest possible battery life, follow these storage instructions:

 

Remove the battery pack from the charger once it is fully charged 
and ready for use.

 

For battery pack storage longer than 30 days:

• 

Store the battery pack where the temperature is below 38°C and 
away from moisture.

• 

Store battery packs in a 30%-50% charged condition.

• 

Every six months of storage, run the battery with a tool until cut 
off by pack’s program control. Then charge the pack as normal. 
charge the battery pack as normal.

BATTERY PACK REMOVAL AND PREPARATION FOR RECYCLING

To preserve natural resources, please recycle or dispose of batteries 
properly.
This product contains lithium-ion batteries. Local regulations may prohibit 
disposal of lithium-ion batteries in ordinary trash.
Consult your local waste authority for information regarding available 
recycling or disposal options.

 

WARNING! 

Upon removal, cover the battery pack’s terminals with 

heavy-duty adhesive tape.  Do not attempt to destroy or disassemble 
battery pack or remove any of its components. Lithium-ion batteries must 
be recycled or disposed of properly. Never touch both terminals with metal 
objects or body parts as short circuit may result. Keep battery packs away 
from children. Failure to comply with these warnings could result in fire 
and/or serious injury.

SYMBOLS

Read the instructions carefully before using the 
product.

Regulatory Compliance Mark (RCM). The product 
meets applicable regulatory requirements.

Waste electrical products should not be disposed 
of with household waste. Please recycle where 
facilities exist. Check with your local authority or 
retailer for recycling advice.

Recycle lithium-ion batteries

Содержание A58BAT14









Отзывы: