AEG A 70120 GS4, Инструкция

Страница: 39 / 44

39
Trouble shooting
During operation of the appliance some smaller but
annoying trouble can often occur, which does not require
calling a technician out. In the following chart
information is given about them to avoid unnecessary
charges on service.
We draw your attention that operation of appliance goes
with certain sounds (compressor- and circulating sound).
This is not trouble, but means normal operation.
We draw it to your attention again that the
appliance operates discontinuously, so the stopping
of compressor does not mean being no-current. That is
why you must not touch the electrical parts of the
appliance before removing it from the mains socket.
GB
If you fail to remedy a problem, please contact the nearest authorized service unit.
Power or operation failure:
In case of power failure during the storage of frozen foods, make sure not to open the freezer door. Once the power failure
is over, the yellow indicator (3) of the quick freeze function will light up and then, 5 hours after restart, it will automatically
go out.
If a short power failure occurs (max. 15 hours) and the product is full, the stored foods will not deteriorate. Otherwise you
must use the stored food as soon as possible (if the temperature of the frozen foods rises, their storability will be shorter).
Check stability of product support (all four feet should stand on floor).
If you fail to remedy a problem, please contact the nearest authorized service unit.
Operation failure
When the electronic system fails to detect the ACTUAL temperature, the alarm indicator will start to flash. The product will
continue to operate with the use of a reserve system until the problem is eliminated by the local service personnel.
Problem
Cooling is too weak.
Cooling is too strong.
No cooling at all.
Noisy operation
Possible causes
Thermostat is set too low.
No sufficient pre-cooling done before freezing
started.
Too large food inserted:
Too much food inserted for freezing at the same time.
Food inserted while still hot.
Door not fully closed.
Thermostat is set too high.
Plug is not properly inserted into socket.
No current in socket.
According to the indicator, the on/off switch (B) is
not switched on.
Product support is not correct.
Remedial action
Set to higher position.
Provide for sufficient pre-cooling time.
Cut food into pieces.
Insert less food.
Insert food of room temperature only.
Check if door is fully closed.
Set to lower position.
Check plug-socket connection.
Check presence of current.
Press the on/off switch (B) for more than a
second.
Check stability of product support (all four feet
should stand on floor).